Hurricane Corrosion Resistant (S2) natural ventilator

For over 25 years, the Hurricane® range vertical vane natural ventilation technology has been built to endure the tough climatic conditions and operating environments. Edmonds® ventilation products are designed, engineered and manufactured at its ISO9001 accredited facility in Seven Hills, Australia.

Hurricane was the first industrial ventilator to incorporate vertical vane design which tests at University of Technology Sydney have shown to be have an improved co-efficient of discharge (Cd) compared to similar sized traditional spherical vents.

Hurricane range of Special Variation Corrosion Resistant (S2) ventilator are designed for use in moisture rich, oxidative and slightly acidic conditions. It will also be suitable for dusty polluted environments, where abrasive particles and volatile organic compounds (VOCs) can be found. When polyolefin coated and protected, it can be applied to slightly caustic environment that is corrosive to aluminium. Applications include, sulphuric acid handling facilities, storage tanks and sewer pipe.

Features and benefits
Applications
Accessories
Colours and coating
Specification
Specification
Roof mounted ventilators shall be Hurricane® Corrosion Resistant 100/150/300/400/450/500/600mm (model S2 100/150/300/400/450/500/600) vertical vanes ventilators and shall be manufactured from standard aluminium, corrosion resistant marine grade aluminium or higher, aluminium shaft, aluminium bracket, stainless steel fasteners and rivets. The main bearing holder assembly shall be Glass Filled Nylon (PA6-GF30) installed with an aluminium deflector and not be in the line of air flow. Ventilators top shall be powder coated inside and outside with Colorsteel® / white polyolefin coating or as specified by the customer at time of confirmation. Ventilator tops shall be mill finished or powder coated with Colorsteel® or as specified by the customer at time of confirmation. The ventilator shall be weather-tight under proper installation and normal operating conditions, and capable of withstanding a wind speed of 205.2km/hr as tested by CSIRO. The ventilator shall be manufactured by CSR Edmonds® of New South Wales (1800 332 332) including applicable bases, dampers, fixings, trims, straps, flashings and other specified fittings manufactured by CSR Edmonds® as specified herein, or equivalent.
Warranty
Share
Contact us
General enquiries:
0800 277 123
Email:
Edmonds@csr.co.nz
Case studies

Browse our commercial & industrial case studies to see how Edmonds can help your project